Suchergebnisse

Sure I´ll try that! thanks!

Hello fibre thanks for your feedback! I´ve used the paper towel solution for a long time but, as you said, it allways get wet and molded. Then I tried to hold the plastic bag on the tray sides with paper clips but they cause problems to slide the grounds tray into the slot. The magnets are really cheap and have multiples uses. Why do you say the plastic bags should be avoided? I think it´s a eco friendly idea as long as the goal is to wash and reuse the bags, not dispose them every time.

Hello friends, tired of finding lots of molder in the grounds tray, I´ve been using a plastic bag held in the grounds tray by some neodimium magnet pairs: one magnet inside and another outside. The magnets must have low profile to slide into he tray slot without problem. These magnets can be bought in chinese sites, the low profile ones are particularly cheap. I hope it helps. The machine in the pictures is a Delonghi 23.210.

Hello friends, googling a lot after wiring diagrams I´ve found... Content deleted by Admin

Dear friends, thanks for your time and help, I´ve finally managed to connect all the wires, although I cannot make the machine work because the PIC ucontroler is short circuited. thanks again and sorry for any problem. regards!

Sorry about that.

Thanks Roland11! I´ve already ordered the missing components including a proper 3W resistor [img]https://www.kaffee-welt.net/wcf/images/smilies/emoji/people/1f602.png[/img], just waiting them arrive from China in the next 60 days kkkkkk.

Hi, I´ve been working on a delonghi ESAM machine and I´ve noticed some of the Pressure plastic tube clips missing. I´ve found them in EBAY but they´re expensive considering the shipping. What do you guys do when one of this clips are missing? Is there any way to replace it by anything else? regards,

I don´t have a 3W resistor at this moment, just used this 1/4W to test the board as long as the resistor works as a fuse... Is there any site where we can download/buy the service manuals of the Delonghi machines?

Great post! I have one just like this with the same symptoms, in my case one of the 470uF had blown off. I guess this mess is caused by an inverted Fase-Neutral polarity what do you think?

Thanks for your answers, yes, it´s a 5450 EX1. Unfortunately almost all the wires were cut by the technician so it´s really difficult to reassemble. In the board there are no names for the devices to be connected (at least not in the model I have). I´ve tried to figure out but I´m afraid to burn something. Everything seems to be ok (cup heater, boiler etc.) I´ve been trying to get it´s repair manual for a couple of days with no success. I´ve found other models service manuals but not this one. I…

Hello friends, sorry for the English in your forum but this was the only place I´ve found information about the Delonghi 5450 machine and I just can´t write/read in German. I´ve found this jewel in a Delonghi service here in Brazil, the technician couldn´t repair the power board and this specific model is not supported by the Brazilian Delonghi, so I cannot have access to it´s repair manual. I´ve already found the problem of the power board, the usual: LNK364 (shorted), TL431 (defective) and the…