Suchergebnisse

I managed to get a replacment thermoblock for just 36 euros. The machine is working again! Thank you all for the support! and what a difference the coffee is extremely hot compared with the old thermoblock Kind regards, Patrick

I have tried both brewing units. it doesn't make any difference at all My esam 4500 makes real coffee solid cookies you can hold between your fingers. this unit esam 5400 isnt doing the same, it fells in the disposable container en breaks in 1 big mass. Is this normal?

Are this the instructions ? kaffee-welt.net/index.php?page=DatabaseItem&id=71

I have bought a second hand ESAM 5400 because of my ESAM4500 broke down. No i have these three issues witch i think, maybe are related to each other. Issue 1. The front door sometimes springs open 2. The grinded coffee is not as compact as my old esam 4500. 3. When i grind the beans fine there is no problem, when i grind the beans less fine it show problems that it is grinded to fine. Any sugestions?

My joy was for a verry short time, 1 day after use the machine wasn't heating anymore. I am going to find a cheap replacement 6mm thermoblock. I bought a second hand esam 5400 perfecta for 70 euro. so i can drink coffee for now : ) I have one issue with the esam 5400 but i will start a new threath for it

Hi Stefan, i have managed to fix it!!!!! i am so Happy It does not deserve any credits but this is what i have done. The top thermoblock has a U form heating pipe. When i measured it it was dead. i have measured voltage when it was on and i was getting around 148 volt. So i was sure the heating pipe was dead. I took a peace of metal ( to sink nails in wood ) and a gave it 7 strokes with a hammer ( gently ) I measured again and i was getting results. I turned on the machine and it was working aga…

You are 100% right. The top heater is not heating, the heat i felt was from the U form heater at the back. I felt when the device was screwed back together, so it looked like the silver plate for the cups was heating. But it is not. I dont measure anything from the sensor ( marked red ) or do i need to detached it from the PCB and from the back heater before measuring. I gues my top heater ( thermoblock is defective ) Is there anyway to fix this or does it need to be replaced. It has a mark of 6…

Hi Stefan, thanks for you response. As far as i can translate te manual i can have measured the following results Green heating block - nothing measured 2x Thermal fuse = OK Thermosensor 118,2 Yellow 54 ohm Red thermosensor - nothing measured Antriebsmotor 260 ohm Solenoidspulen 2,36 Kohm Does this makes anyting clear?

Hello, i have been looking to this form for a few days, this is the best forum regarding repairs i could find, The only downside for me is the language. i am from holland, and i have a bit problems translating to dutch using google translate. So i hoped someone could help me in english. I have a ESAM 4500 wit the following error. 1. Power on machine 2. Warming UP. 3. Geneneric Alarm. I feel both heaters are hot, yesterday the device was working again after turning it on and off a few times, and …